Gamma 6004 STRINGING MACHINE 6 POINT SC MOUNTING (Issue Manual do Utilizador Página 1

OWNER’S MANUALIssue 11A - February 2014STRINGING MACHINE60046 POINT SC MOUNTING

10Setting TensionThe spring tensioner utilizes a rotary adjust-ing knob along with a linear tension scale to indicate the tension setting. The

11Getting StartedTo begin stringing the main strings, thread the two ends of the string through the two center holes at the appropriate end of the

12Weaving the Cross StringsWeave the cross strings over and under the main strings being careful to alternate the weave direction of each consecutive

13PATHFINDER AWLOnce the awl is inserted, pull the handle of the awl outward while holding the tip section in place. This leaves the outer sheath in

14BAMAINTENANCE & ADJUSTMENTSIf the lever releases before 60 lbs., using the supplied L-shaped hex wrench, turn the adjustment screw (B

15MAINTENANCE & ADJUSTMENTSAdjusting the Tensioner BrakeAfter stringing many racquets, the brake of the tensioner may need to be adjusted. Wi

16MAINTENANCE & ADJUSTMENTSAdjustmentKnobString Clamp AdjustmentThe string clamps will need minor adjust-ments according to string type, con

17TROUBLESHOOTING TIPSCARE & CLEANINGWith time and use, the clamping surfaces of your machine may become oily or dirty and result in string or cl

18PARTS LIST 6B CAP SCREW- M8x30 104A TENSIONER ASSEMBLY 105 RETAINER SCREW 112 TOOL TRAY 113 LONG LEG 114 SHORT LEG 115 FLAT HEAD SCRE

19MDCSC13MSAC11PARTS DRAWING1211151141133201121193373273366B165285283286289304361386105120A165MFSPP13340MBMSP11MMSPP13104A116140144146A384371341385383

2TABLE OF CONTENTSWARRANTY ...PAGE 2FEATURES...

GAMMA SPORTS 200 Waterfront DrivePittsburgh, Pennsylvania 15222 Phone: 800.333.0337 Fax: 412.323.0317 Visit our website at www.gammasports.comCopyrig

3MACHINE FEATURESMACHINE FEATURES Manual Spring Tension Winder with 11 to 89 lbs Tension Range Patented Roller Guide for Maximum Accuracy and Cons

46004Unpacking Instructions & ContentsInstructions for Unpacking and Preparing for AssemblyThe stringing machine is shipped in two cartons, a Mast

5ASSEMBLY INSTRUCTIONSBase Leg AssemblyThe stringing machine uses a four leg base design. The legs must be assembled to the lower column support befo

6ASSEMBLY INSTRUCTIONSBellows InstallationThe bellows assembly is supplied in two pieces and should be assembled as follows. Place the bellows

7ASSEMBLY INSTRUCTIONSTurntable and Mounting System InstallationTo install the turntable position the turntable over the turntable pin and al

8 ASSEMBLY INSTRUCTIONSMOUNTING THE FRAMEMounting Stand AdjustmentTo adjust the spacing between the mount-ing stands, turn one

9Frame Shoulder Support AdjustmentThe shoulder supports are designed to rotate and can be adjusted to provide maximum support to the racquet fram